Vicon CE202D-WN Installationsanleitung PDF herunterladen (Seite 12)

3.6 Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup>System> Maintenance

web page (described in “3.5.6 System > Maintenance”) or use the Reset button on the network

camera, as described below.

• Using the Reset Button

Follow the instructions below to reset the Network Camera to the factory default settings using

the Reset button.

1. Power off the network camera by disconnecting the power adapter.

2. Remove lower dome, if not already done so.

2. Press and hold the Reset button with a straightened paperclip while reconnecting the power.

3. Keep the Reset button pressed for about 2 seconds.

4. Release the Reset button.

5. The network camera resets to factory defaults and restarts after completing the factory

reset.

The unit now obtains the IP address automatically via DHCP

6. Reattach the dome.

3.7 More Information

For more information, refer to the network camera User’s manual, which is available on the CD

included in this package.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Vicon CE202D-WN Installationsanleitung Seite 12