Vicon Roughneck V920D Series Installationsanleitung PDF herunterladen (Seite 12)

2. Using the drilling guide as a template, mark the location of the four mounting holes [0.203 in.

(5.2 mm) diameter]. See Figure that follows.

Mounting Hole Pattern

3. There are two (2) cable access holes provided. Drill a hole in the wall or ceiling and route video

and power cables to the selected location and through one of the cable access holes. A 1/2-inch

connection (customer-supplied connector) is provided on the side of the base. A conduit or

electrical connector (screw-type) can be used in this threaded hole. The rear port is sized to

accept a 1/2-in. (customer-provided) connector. If it is desirable to use the rear cable access hole,

route the conduit through the hole; the supplied grommet can be used instead of the conduit.

Apply the provided sealant tape around the threads of the conduit pipe. See Figure above for hole

locations.

4. If using the rear cable access hole, insert the vent plug provided in the side cable access hole. If

the side cable access hole is used, insert a Street Tee (customer provided) into the cable access

hole. Route the conduit through the top hole and insert the vent plug provided into the bottom

hole. Refer to Figure that follows for installation options. Sealant tape is provided for the plug and

Street Tee. Insert the black plug provided into the rear cable access hole if the side access hole is

being used; if the rear cable access hole is being used, insert the provided plug into the side cable

access hole and tighten with tool provided.

Note: Failure to thoroughly coat threads will result in moisture entering the housing and eventual

failure of the unit.

Note: For outdoor installations, Vicon recommends that the vent plug should only be used if

fogging conditions exist. Additionally, if the side cable access hole is used, the base must be

mounted so the hole is pointed directly downward.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Keine Kommentare

Vicon Roughneck V920D Series Installationsanleitung Seite 12