Vicon Roughneck V920D Series Installationsanleitung PDF herunterladen (Seite 76)

3.8 Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup>System> Maintenance

web page (described in “3.5.6 System > Maintenance”) or use the Reset button (SW1) on the board

of the dome camera, as described below:

• Using the Reset Button

Follow the instructions below to reset the network camera to the factory default settings using

the Reset button.

1. Power off the network camera by disconnecting the power adapter.

2. Remove the lower dome.

3. Press and hold the Reset button (SW1) on the board with your finger while reconnecting

the power.

4. Keep the Reset button (SW1) pressed for about 2 seconds.

5. Release the Reset button (SW1).

6. The network

camera resets to factory defaults and restarts after completing the factory

reset.

The unit now obtains the IP address automatically via DHCP.

7. Reattach the lower dome.

CAUTION: When performing a Factory Reset, you will lose any settings you have saved.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82

Keine Kommentare

Vicon Roughneck V920D Series Installationsanleitung Seite 76